Toyota Camry

1992-1997 of release

Repair and car operation


Kamri's Toyota
+ General data
+ 1. Maintenance
+ 2. Engine
+ 3. Six-cylinder V6 engines
- 4. Major maintenance of engines
   4.2. General information
   4.3. Compression check
   4.4. Recommendations about engine removal
   + 4.5. Removal and engine installation
   4.6. Sequence of dismantling of the engine
   4.7. Dismantling of a head of the block of cylinders
   + 4.8. Cleaning and survey of a head of the block of cylinders
   4.9. Assembly of a head of the block of cylinders
   4.10. Removal of pistons with rods
   4.11. Removal of a cranked shaft
   + 4.12. Block of cylinders of the engine
   4.13. Pistons and rods
   4.14. Cranked shaft
   + 4.15. Survey and choice of radical and shatunny bearings
   4.16. Control люфта balance weight assemblies (engine 5S-FE)
   4.17. Engine balance of assembly at major maintenance
   4.18. Installation of piston rings
   + 4.19. Installation of a cranked shaft and check of working gaps of bearings
   4.20. Installation of a back sealing ring of a cranked shaft
   4.21. Installation of pistons and rods, check of working gaps of bearings
   4.22. Installation of assembly of the balance weight (engine 5S-FE)
   4.23. Engine start after major maintenance
+ 5. Cooling and heating
+ 6. Fuel system
+ 7. Ignition system
+ 8. Toxicity fall
+ 9. Transmission
+ 10. Automatic transmission
+ 11. Coupling and power shafts
+ 12. Brake system
+ 13. Suspension bracket
+ 14. Body
+ 15. Electric equipment



4.6. Sequence of dismantling of the engine
GENERAL INFORMATION

Removal of the right suspension bracket of the power unit

 
Prevention

At dismantle of the specified details pay attention to features of their removal. Remember positions of installation of laying, sealing rings, pro-rates, pins, arms, washers, bolts and other fine details.

Engine installation on the special stand considerably facilitates assembly dismantling processes. Before engine installation with the stand shoot a flywheel and a back sealing ring.

In the absence of the stand engine dismantling on a floor is possible. At work in these conditions observe extra care.

If you got the restored engine, on it from the old engine it is necessary to rearrange the following knots:

– generator and arms;
– details of control of emission of exhaust gases;
– ignition distributor; spark plugs and высоковольт ny wires;
– thermostat and thermostat cover;
– water pump;
– EFI system elements;
– inlet and final collectors;
– oil filter;
– suspension brackets of the power unit;
– coupling and flywheel

If you plan complete major maintenance of the engine, disassemble the engine on making details in the following order:

– inlet and final collectors;
– cover of a head of the block of cylinders;
– casings of a gear belt;
– gear belt and pulleys;
– heads of the block of cylinders;
– oil pallet;
– oil pump;
– balance weight assembly (engines 5S-FE);
– pistons and rods;
– back cover of a cranked shaft;
– cranked shaft and radical bearings.