Toyota Camry

1992-1997 of release

Repair and car operation

Kamri's Toyota
+ General data
+ 1. Maintenance
+ 2. Engine
+ 3. Six-cylinder V6 engines
+ 4. Major maintenance of engines
+ 5. Cooling and heating
+ 6. Fuel system
+ 7. Ignition system
+ 8. Toxicity fall
+ 9. Transmission
+ 10. Automatic transmission
+ 11. Coupling and power shafts
+ 12. Brake system
- 13. Suspension bracket
   13.2. General information
   - 13.3. Forward stabilizer of cross-section stability
      13.3.2. Installation
   + 13.4. The lobby is resistant
   13.5. Repair of a forward rack
   + 13.6. Bottom lever of a forward suspension bracket
   13.7. Replacement of the bottom hinge of a forward suspension bracket
   + 13.8. Rotary fist
   13.9. Back stabilizer of cross-section stability
   + 13.10. Rack of a back suspension bracket
   13.11. Longitudinal draft of a back suspension bracket
   + 13.12. Levers of a back suspension bracket
   + 13.13. Nave of a back suspension bracket
   + 13.14. Fixing element of a back nave
   + 13.15. Steering wheel
   + 13.16. Tips of steering draft
   13.17. Replacement of protective covers of steering transfer
   + 13.18. Steering transfer
   + 13.19. Pump of the amplifier of a steering
   13.20. Air removal from steering system with the amplifier
   + 13.21. Wheels and tires
   13.22. Corners of installation of wheels
+ 14. Body
+ 15. Electric equipment

13.3. Forward stabilizer of cross-section stability

13.3.1. Removal

PERFORMANCE ORDER

1. Lift a forward part of the car and fix on supports. Remove forward wheels.
2. Unscrew on three bolts and remove protection of the right and left forward wings.
3. Unscrew drafts of the stabilizer from the bottom levers of a forward suspension bracket.

4. Unscrew drafts of the stabilizer from the stabilizer of cross-section stability.	5. Unscrew bolts of fastening of the clips, fixing the stabilizer of cross-section stability to the bottom frame.
6. Remove a reception exhaust pipe.
7. Unscrew bolts of fastening of steering transfer.
8. Remove steering transfer and take the stabilizer of cross-section stability from under the left wing.
9. Check the stabilizer on lack of wear and mechanical damages. Special attention give to a condition of plugs of installation of the stabilizer.
	10. Check a condition of the spherical hinge of draft of the stabilizer. For check of a condition of the spherical hinge establish draft of the stabilizer in a vice, screw on a pin of the spherical hinge a nut and, using a dinamometrichesky key, turn 4 times a pin of the spherical hinge and, turning the 5th time a pin of the spherical hinge, define a torque which is necessary for putting for a provorachivaniye of a pin of the spherical hinge. The torque size for a provorachivaniye of a pin of the spherical hinge should make from 0,5 to 10 Nanometers. Otherwise replace draft of the stabilizer.